Understanding the Early Effect

This technical brief discusses the Early effect and how it influences the amplification characteristics of a bipolar junction transistor.

In a previous article, I discussed channel-length modulation, which is something that occurs in a FET and causes the drain current to be dependent on the drain voltage (or more specifically the drain-to-source voltage). If we ignore channel-length modulation, the drain current in the saturation region is dependent only on the gate-to-source voltage and the physical characteristics of the FET. This would be pleasantly straightforward, but for some reason reality is often more complicated than we want it to be.

The Early Effect

It turns out that an analogous phenomenon affects the operation of a bipolar junction transistor. A BJT doesn’t have a channel, though, so we need a different name; at some point people decided on the “Early effect,” after James Early, though you will see shortly that we could also call it “effective-base-width modulation.”

We usually say that the collector current of a BJT in active mode is equal to the base current multiplied by β. This implies that the gain of the transistor is not affected by the conditions at the output. This simplifies the analysis; also, a transistor operating in this way would have no distortion caused by a gain that changes as the output voltage changes.

This approach is acceptable for approximations and for the DC-bias portion of BJT design and analysis, but when we’re dealing with small-signal amplifiers, we need to consider the Early effect:

• First, let’s assume that the emitter voltage (V_E) is constant. This means that we have two important voltages that are both referenced to an unchanging V_E: the collector-to-emitter voltage (V_CE) and the base-to-emitter voltage (V_BE).
• Let’s also assume that the output is taken from the collector, such that variations in the output voltage (V_OUT) are also variations of V_CE.

• If a small increase in V_BE causes a large increase in V_OUT, the collector-base junction becomes more reverse-biased (remember that in active mode the base-emitter junction is forward-biased and the collector-base junction is reverse-biased).
• This causes the junction’s depletion region to become wider, which in turn decreases the effective width of the base. We say “effective” because the physical width of the base region doesn’t change.
• The saturation current (I_S) is inversely proportional to the effective width of the base, and thus an increase in V_OUT will lead to an increase in I_S.
• If I_S increases, collector current also increases, as you can see from the following formula:

IC=ISeVBEVT

Accounting for the Early Effect

If we hold V_BE constant and plot collector current vs. V_CE in active mode, the result for a simplified BJT would be a straight and flat line, indicating that the collector voltage has no effect on the gain, i.e., the relationship between V_BE and I_C. This is also what we observe in the above formula, which does not have a V_CE term.



If we incorporate the influence of effective-base-width modulation, the line is still straight but it is no longer flat. Rather, it has an upward slope, indicating that the output voltage affects the gain, because for a given V_BE the collector current will be higher if the collector voltage is higher.



If you trace this line back to the point at which it crosses the horizontal axis, you have the Early voltage, denoted by V_A, and then you can more accurately determine collector current by using the following formula:

IC=ISeVBEVT(1+VCEVA)