Belt Conveyor Types | Troughed Belt Conveyor | Flat Belt Conveyor

Types of conveyor:

  • Troughed belt conveyor

  • Flat belt conveyor


Troughed belt conveyor:


01-trough belt conveyor-troughed belt conveyor design-troughed conveyors-troughed roller conveyors
Troughed belt conveyor is that in which the belt forms a trough on the carrying side while running over idler rollers which are either in set of 5 rolls, 3 rolls or 2 rolls. The troughing angle adopted are: 15°, 20° , 25° , 30° , 35° , 40° , 45° . Return idlers are usually straight roller type.


Transverse flexibility or rigidity of the belt is another significant consideration. It is important that the belt trough properly. The empty conveyor belt must make sufficient contact with the center roll in order to track properly.


01-types of conveyors-troughed belt conveyor-quarry conveyor belt-troughed belt conveyor design


Troughed belt conveyors are used for higher capacity, higher speed requirement, and for handling bulk material of large lump size. It suitable for inclined or declined type conveyors.


01-transition distance-troughed belt conveyor-belt conveyor technology-belt conveyor take up-belt conveyor tension calculations


Transition distance is defined as the distance from the center line of the first fully troughed idler roll to the center line of either the head or tail pulley. The distance from the pulley to the top of the wing idler is certainly greater than the distance from the pulley to the center roll of the troughing set. If the transition distance is too short, the edge of the belt can be over stretched. This will adversely affect the load support and belt life.



Flat belt conveyor:


Flat belt conveyor is that in which the belt runs flat on the carrying side over straight roller type idler or a set of idlers.


01-flat conveyor chains- flat conveyor parts-flat conveyor roller-flat conveyor idlers-belt conveyor trajectory-belt conveyor working principle-belt conveyor weighing system


Flat belt conveyors are suitable for lower capacity, low speed requirement and for handling unit goods or bulk material of small lump size and higher angle of repose. Declination is undesirable.
Post a Comment
My photo

Hi, I`m Sostenes, Electrical Technician and PLC`S Programmer.
Everyday I`m exploring the world of Electrical to find better solution for Automation. I believe everyday can become a Electrician with the right learning materials.
My goal with BLOG is to help you learn Electrical.
Powered by Blogger.