Moulding Tools:
1. Shovel:
It
is just like rectangular pan fitted with a handle. It is used for
mixing the moulding sand and for moving it from one place to the other.
2. Riddle:
It is used for removing foreign materials like nails, shot metal splinters of wood etc from the moulding sand.
3. Rammer:
It is a wooden tool used for ramming or packing the sand in the mould. Rammers are made in different shapes.
4. Strike-off bar:
It is a cast iron or wrought iron bar with a true straight edge. It is used to remove the surplus sand from the mould after the ramming has been completed.
5. Vent wire:
It is a mild steel wire used for making vents or openings in the mould.
6. Lifter:
It is a metal piece used for patching deep section of the mould and removing loose sand from pockets of the mould.
7. Slick:
Different types of slicks are used for repairing and finishing moulds.
8. Trowel:
It contains of a flat and thick metal sheet with upwards projected handle at one end. It is used for making joints and finishing flat surface of a mould.
9. Swab:
It is made of flax or hemp. It is used for applying water to the mould around the edge of the pattern.
10. Draw spike:
It is a metal rod with a pointed or screwed end. It is used for removing the pattern from the mould.
1. Shovel:
2. Riddle:
It is used for removing foreign materials like nails, shot metal splinters of wood etc from the moulding sand.
3. Rammer:
It is a wooden tool used for ramming or packing the sand in the mould. Rammers are made in different shapes.
4. Strike-off bar:
It is a cast iron or wrought iron bar with a true straight edge. It is used to remove the surplus sand from the mould after the ramming has been completed.
5. Vent wire:
It is a mild steel wire used for making vents or openings in the mould.
6. Lifter:
It is a metal piece used for patching deep section of the mould and removing loose sand from pockets of the mould.
7. Slick:
Different types of slicks are used for repairing and finishing moulds.
8. Trowel:
It contains of a flat and thick metal sheet with upwards projected handle at one end. It is used for making joints and finishing flat surface of a mould.
9. Swab:
It is made of flax or hemp. It is used for applying water to the mould around the edge of the pattern.
10. Draw spike:
It is a metal rod with a pointed or screwed end. It is used for removing the pattern from the mould.
No comments:
Post a Comment