Conveyor Take-up Arrangement:
All belt conveyors require the use of some form of take-up device for the following reasons:
- To ensure adequate tension of the belt leaving the drive pulley so as to avoid any slippage of the belt
- To ensure proper belt tension at the loading and other points along the conveyor
- To compensate for changes in belt length due to elongation
- To provide extra length of belt when necessary for splicing purpose.
Usually there are two types of take up arrangements.
- Fixed take up device that may be adjusted periodically by manual operation
- Automatic take up devices for constant load type
In
a screw take up system the take up pulley rotates in two bearing blocks
which may slide on stationery guide ways with the help of two screws.
The tension is created by the two screws which are tightened and
periodically adjusted with a spanner. It is preferable to use screws
with trapezoidal thread t decrease the effort required to tighten the
belt.
The
main problem with the use of manual take-up is that it requires a
vigilant and careful operator to observe when take up adjustment is
required. Perfect tension adjustment with this system is also not
possible. For this reason these devices are used only in case of short
conveyors of up 60 m length and light duty.
In automatic take up arrangement the take up pulley
is mounted on slides or on a trolley which is pulled backwards by means
of a steel rope and deflecting pulleys. The carriage travels on guide
ways mounted parallel to the longitudinal axis of the conveyor, i.e.,
horizontally in horizontal conveyors and at an incline in inclined
conveyors. Hydraulic, pneumatic and electrical take up devices are also
used.
Automatic take-up has the following features:
- It is self adjusting and automatic
- Greater take-up movement is possible
No comments:
Post a Comment