Determination of Xd and Xq Using Slip Test - LEKULE

Breaking

20 Sept 2015

Determination of Xd and Xq Using Slip Test

The method used to determine Xq and Xd, the direct and quadrature axis reactance is called slip test.
       In an alternatore we apply excitation to the field winding and voltage gets induced in the armature. But in the slip test, a three phase supply is applied to the armature, having voltage must less than the rated voltage while the field winding circuit is kept open. The circuit diagram is shown in the Fig. 1.
Fig.1  Circuit diagram for slip test
       The alternator is run at a speed close to synchronous but little less than synchronous value.
       The three phase currents drawn by the armature from a three phase supply produce a rotating flux. Thus the armature m.m.f. wave is rotating at synchronous speed as shown in the Fig. 2.
Fig. 2  Rotating armature m.m.f.
       Note that the armature is stationary, but the flux and hence m.m.f. wave produced by three phase armature currents is rotating. This is similar to the rotating magnetic field existing in an induction motor.
       The rotor is made to rotate at a speed little less than the synchronous speed. Thus armature m.m.f. having synchronous speed, moves slowly past the filed poles at a slip speed (ns -n) where n is actual speed of rotor. This causes an e.m.f. to be induced in the field circuit.
       When the stator m.m.f. is aligned with the d-axis of field poles then flux  Φd per poles is set up and the effective reactance offered by the alternator is Xd.
       When the stator m.m.f. is aligned with the q-axis of field poles then flux  Φq per pole is set up and the effective reactance offered by the alternator is Xq.
       As the air gap is nonuniform, the reatance offered also varies and hence current drawn the armature also varies cyclically at twice the slip frequency.
       The r.m.s. current is minimum when machine reactance is  Xd and it is maximum when machine reactance is  Xq. As the reactance offered varies due to nonuniform air gap, the voltage drops also varies cyclically. Hence the impedance of the alternator also varies cyclically. The terminal voltage also varies cyclically. The voltage at terminals is maximum when current and various drops are minimum while voltage at terminals is minimum when current and various drops are maximum.
       The waveforms of voltage induced in rotor, terminal voltage and current drawn by armature are shown in the Fig. 3.
       It can observed that rotor field is aligned with the armature m.m.f., its flux linkage are maximum, but the rate of change of flux is zero. Hence voltage induced in field goes through zero at this instant. This is the position where alternator offers reactance Xd. While when rate of change of flux associated with rotor is maximum, voltage induced in field goes through its maximum. This is the position where alternator offers reactance Xq.
The reactances can be calculated as
Fig. 3  Current and voltage wave forms in slip test

No comments: