Full Wave Diode Rectifier

The diode works only when it is in forward bias, only the current flows through p-n junction diode and output current across the load is found.

If two diodes are connected in such a way that one diode conducts during one half of the input voltage and the other one conducts during the next half of the cycle, in a unidirectional can flow through the load during the full cycle of the impact voltage. This is known as full wave rectifier.



According to the diagram given below a center tapped transformer D₁, and D₂ are two p-n junction diodes with similar characteristics D₁ conducts for negative half of the output voltage. Thus we get output voltage and the output current for the entire input cycle.

Circuit Diagram of Full Wave Diode Rectifier

The circuit diagram of the full wave diode rectifier given below,




Full wave rectification can also be achieved using a bridge rectifier which is made of four diodes.
According to the figure, when D1 and D3 are forward biased, they conduct but D₂ and D₄ and on D₁ and D₃ are reverse biased in both cases load current in the same direction.

Bridge rectifier has several advantages over simple full wave rectifier. It performance and efficiency is better than that of the simple full time rectifier.

Input Voltage & Output Voltage Waveform

Now, different parameters for half wave rectifier is given below
The average of load current (I_dc) :
Let, the load current be i_L = I_msinωt





Ripple factor of half wave rectifier,